QUICK ASSEMBLY
Aluminum and stainless steel pipe systems are easy to assemble and easy to modify. Aluminum piping is easier to lift and handle than standard steel piping, and its push-to-connect fittings secure connections with a simple push and twist. The fittings eliminate the need for skilled pipe fitters, special tools, pipe preparation and threading.

Continue reading ‘How Can Aluminum Pipe Help Me?’ »

10 Steps to Reduce Compressed Air Energy Costs

The most expensive component in the total cost of compressed air is energy. In fact, over the lifespan of a typical compressor, energy typically costs several times more than the purchase price of the compressor. The bottom line: maximizing energy efficiency saves you money.

QUICK ASSEMBLY
Aluminum and stainless steel pipe systems are easy to assemble and easy to modify. Aluminum piping is easier to lift and handle than standard steel piping, and its push-to-connect fittings secure connections with a simple push and twist. The fittings eliminate the need for skilled pipe fitters, special tools, pipe preparation and threading.

Continue reading ‘How Can Aluminum Pipe Help Me?’ »

NEWS ALERT: On Dec. 17, President Obama signed legislation that would extend and expand the depreciation bonus through 2012.

Continue reading ‘Small Business Jobs Act’ »

Why it’s time to move beyond inlet valve modulation for compressor control
By David M. McCulloch

The type of compressor capacity control you use and the related pressure settings you select are critical to your overall compressed air system efficiency. For years, many rotary compressors were sold with inlet valve modulation (throttling) as the standard means of capacity control. While this matched compressor output with demand, the system offered much less than desirable energy efficiency.

Did you know?
On September 27, 2010 President Obama signed the Small Business Jobs Act (SBJA).

In addition to providing incentives for small business, the SBJA extended the depreciation bonus (2010 only) and raised Sec. 179 expensing limits through the end of 2011 to encourage equipment purchasing. The economic stimulus law can potentially mean big tax savings for you. Check with a tax expert to see if your business is eligible to take advantage. Disclaimer: Nothing in this advertisement constitutes any kind of tax advice, a promise of potential tax savings or reduced tax liability reference the Small Business Jobs Act or any other rule, law or regulation. Applicability, if any, depends on your situation. For tax advice please consult a taxation expert.

This is a thermal image of a fused disconnect switch that was taken by one of our service technicians. The customer called us in for emergency service due to the compressor shutting down on motor overload. It was quickly determined that the customer had a fuse blown and it was immediately replaced. Upon start up and after performing a complete inspection of the compressor and the electrical supply… the true “Root Cause” of the problem was found at the fused disconnect.

How to minimize cycling, pressure differentials and unloaded run time
By Ron Marshall from Plant Services Magazine

A commonly recommended energy strategy for a lubricant-injected rotary screw air compressor is to add main storage receiver capacity to enable the switch from inefficient modulation control to the more efficient load/unload mode. A typical guideline was to add 1-2 gal of storage receiver volume for every cfm of main compressor capacity.